GRIP Base Connector SWS
Assembly and Operating Manual
1 Operation
2 Safety
2.1 Symbol
2.2 Intended purpose
2.3 Environmental and operating conditions
2.4 Safety indication
Dangers may arise from the unit, if:
•
the product is not installed or inserted properly,
•
the system is not used for its intended purpose,
•
the safety and installation notes are not observed.
CAUTION! Risk of pinching the fingers when closing the Base Connector
Rev. 1.01
2
When closing the connector ensure fingers are not between the upper and lower
assembly.
NOTICE!
The unit may only be operated if the machine in which the unit is installed complies with
the relevant provisions of the machinery directive 2006-42-EC.
Everyone who is responsible for assembly, commissioning and maintenance must read and
understand the complete operating instructions. Improper use, which affects the function und
operational safety of the Base Connector, is prohibited.
This symbol indicates possible hazards to persons or the Base
Connector SWS.
The Base Connector SWS has been designed as an interface between robot and working table.
Furthermore, the Base Connector can also be used in special solutions, automation and also as a
general mechanical standard interface. The unit may only be used in the context of its technical
specifications. The system is intended for the installation in a machine. The requirements of the
applicable instructions must be considered and adhered to.
Use this unit only in dry and splash-proof environments at room temperature as well as within the
application parameters defined in the technical specifications. If this is not the case, warranty
cannot be accepted. Exceptions are units designed especially for the respective conditions.
To open the change system, insert the square socket key on the square of the semi-cylindrical bolt and turn
counter-clockwise (“to the left") by 180 ° to the stop. The upper and lower assembly can now be pulled apart.
When joining the parts, the hand lever must be set to open position. Now, upper and lower assembly can be
pushed into each other.
By turning the semi-cylindrical bolt clockwise (“to the right”) 180° up to the stop, the system is locked. Afterwards
the hand lever is folded and latched.
