Model 7100 Portable Pin Welder
3
OPERATOR SAFETY
Our first concern at Gripnail is the safety of the operators using our equipment. As with
most types of welding equipment, there is always a potential for serious injury if the
equipment is misused. Please familiarize yourself with the equipment before operating.
Below is a list of a few safety precautions that should be observed.
1.
READ
this manual before you begin using the equipment.
2.
DO NOT OPERATE
this welder in or near water or damp areas.
3.
DO NOT LOOK
directly at the weld pin while welding. Arcing produced by the
welding process could cause flash burns to your eyes and could cause blindness.
4.
WEAR
protective clothing to prevent skin burns from weld slag.
5.
DO NOT TOUCH
the pin or adjacent area after welding until sufficient time is al-
lowed for cooling. Otherwise, serious burns may result.
6.
DO NOT OPERATE
the welder unless all covers are in place.
7.
DO NOT PULL
or move the welder by the attached cables or damage to the cables
will result.
8.
CONTACT
the Gripnail Service Department for assistance with replacement parts,
repairs, questions or diagnosing a problem with the welder.
Gripnail Customer Service Department
Gripnail Corporation
97 Dexter Road
East Providence, Rhode Island 02914
Phone: (800) 474-7624
(401) 431-1791
Fax: (401) 438-8520
Email: gripnail@gripnail.com
Website: www.gripnail.com
