www.gripone.com
4.2 Installation of sensors
To calculate the speed of the motorcycle, GRIPONE CHRONO TC uses two speed sensors.
1) Sensors must be placed where they can detect the passage of the bolts of the front and rear
brake disk. It is provided a kit of universal brackets for mounting sensors.
2) The front bracket must be placed using the screws of the fork leg that tighten the wheel axle’s.
3) The rear brackets must be fixed under the rear axle nut. The L-type bracket must be fixed to
the Y-type bracket to position the rear sensor in front of rear disk bolts.
4) On the sensors is designed a viewfinder. It must be
facing to the bolts of brake.
5) Once set the sensors (by the M3 bolts) check the
distance between the bolt head and the sensor: it must
be equal to (approximately) 2mm (between 1mm and
3mm). If the distance is too big, the sensor can not
detect the bolt. If the distance is too small, you risk
damaging the sensor.
Please note:
When connecting sensors to the control unit, it is important to do not confuse the front and rear
sensor. Connect the front sensor to the long arm of harness. Connect the rear sensor to the short
arm of harness. Reffer to the picture of harness.
Summary of Contents for CHRONO TC
Page 5: ...www gripone com ...
Page 9: ...www gripone com ...