r3a-x2.0
20
2.
a second time and you will be in CAM MODE
and the CAM MODE Light will be on.
3.
a third time, both MODE lights will be off and
you will be back to the initial mode – Time
Code Mode.
By default the system starts up in Time Code Mode,
which is evident by the time codes on the Display.
SYS and CAM MODE are needed for Advanced
Operations. For Basic Operation, leave this on Time
Code Mode.
REC Button
Start/stop recording on the current Preview Camera
by pressing REC. This assumes that the PWR button
has been previously pressed. Pressing REC will cause
the CAM[1,2,3] STATUS Light to become solid green
when the camera is recording and flashing green
when the camera is not recording.
If you press and hold the REC button for greater than
2 seconds, all cameras will start recording nearly
simultaneously. But when stopping the record, each
camera must be stopped separately - as described in
the above paragraph.
Menu Knob
The Menu Knob sits just below the Mode Button.
This knob acts as a dial (twist right and left) as well as
a button (press).
This knob is used along with the selected MODE
(CAM, SYS or Time Code) to do more advanced
operations. For basic operation, you will not need to
use this knob.
