r3a-x2.0
43
Pan/Tilt & Zoom Control :
Configuring the response for the Zoom and/or Pan/Tilt
control is done via the SYS MODE Menu options
Configure
Zoom
and/or
Configure PanTilt
as described in Table 1.
The configuration consists of selecting the
speed vs. percent of
joystick range
curve and, if desired, a deadband.
The
speed vs. percent of joystick range
curve can be any of the
following:
Table 2 -
Curve
Configuration
Fixed Speed
With a fixed curve, once you have
passed the deadband value, the speed
will stay at the fixed speed.
Linear Curve With a linear curve, the speed increases
at a constant rate as the joystick is
pushed further.
Exponential
Curve
With an exponential curve, the speed
starts out slower and ramps up faster as
the joystick is pressed further. Curve
values can be 1-9, where 1 is close to
linear and 9 contains the largest possible
ramp.
