60
GB
• Always keep the equipment clean.
After using the equipment, it is im
-
perative to:
- Clean the blade
(with an oily cloth);
- Oil the blade shaft
with an oil can or
spray.
• Slight notches on the blades can be
evened out. For this, sand down the
blades with an oil stone. Only sharp
blades can cut properly.
• Blunt, bent or damaged blades must
be changed.
Storage
• Keep the trimmer in the blade guard
supplied, in a dry place and out of
reach of children.
• Store the unit horizontally or assured
against falling over. Bring the cutting
unit in storage location.
• Store the battery only in a partially
charged state. The state of charge
should be 40 – 60 % over a longer
storage period.
• Store the equipment between 10°
C and 25° C. During storage, avoid
extreme cold or heat so the battery
does not lose power.
• During a longer storage period, check
the state of charge of the battery and
recharge if necessary roughly every
3 months.
Technical Data
Appliance ..............AHS 2020 T-Lion Set
Motor voltage ................................ 20 V
Blade speed.................... 1200 min
-1
(rpm)
Protection class ......................................III
Weight
(without battery and charger) .....3.15 kg
Blade length..................................450 mm
Cutting length ...............................410 mm
Cutting capacity ..............................16 mm
Sound pressure level
(L
pA
) ..................... 77,9 dB(A), K
pA
= 3 dB
Sound power level (L
WA
)
guaranteed ...............................91 dB(A)
measured ..........89 dB(A); K
WA
= 2.19 dB
Vibration (a
h
)
Rear handle.............................2.69 m/s
2
Front handle ............................3.04 m/s
2
K=1.5 m/s
2
Noise and vibration values have been de-
termined according to the standards and
regulations mentioned in the declaration of
conformity.
Technical and optical changes may be
undertaken in the course of further de-
velopment without notice. All dimensions,
references and information in this instruc-
tion manual are therefore not guaranteed.
Legal claims made on the basis of the
instruction manual can therefore not be
considered as valid.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to
compare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
