113
GB
lines should always overlap by a few
centimetres.
• Do not move backwards.
• On slopes, always work across the
slope.
• If the blade comes into contact with
a foreign body, switch off the engine
immediately. Wait until the blade is
stationary and check the equipment
for damage. Restart work only if the
equipment is undamaged.
• Switch off the equipment during long-
er breaks and for transportation and
wait until the blade is stationary.
• Clean the equipment after each use,
as described in the “cleaning and
maintenance“ chapter.
Cleaning and
Maintenance
Have any repair and mainte-
nance work not described in
these instructions carried out by
a specialist workshop. Use only
original Grizzly replacement
parts. Risk of accidents!
Carry out maintenance and clean-
ing work strictly with the engine
switched off and spark plug con-
nectors removed. Risk of injury!
Allow the equipment to cool
before any maintenance and
cleaning work. Elements of the
engine are hot. Risk of burning!
Wear gloves when handling the
blade.
Please observe the cleaning and
maintenance work and also the de-
livered operating instructions from
Briggs & Stratton.
Cleaning and General
Maintenance Work
Do not tilt the equipment sideways
or forwards. Operating fluids could
leak out and the engine could be
damaged.
• Always keep the equipment clean. To
clean, use a toothbrush or cloth but no
corrosive cleaning agents or solvents.
Do not use water to clean the engine
as it could contaminate the fuel sys-
tem.
• After mowing, remove plant remains
that are stuck to the equipment by us-
ing a piece of wood or plastic. Clean
the vent holes, ejection hole and blade
area especially. Do not use hard or
pointed objects, which could damage
the equipment.
• Oil the wheels from time to time.
• Before each use, check the lawnmow-
er for obvious defects such as loose,
worn or damaged parts. Check that all
nuts bolts and screws are sitting firmly.
• Check covers and guards for damage
and that they are sitting correctly. Re-
place if necessary.
Replacing the Air Filter
Do not operate the equipment
without the air filter otherwise dust
and dirt will get into the engine and
result in damage to the machine
1. Release the screw at the air fil-
ter cover (10) and flip open the
cover
2. Remove air filter (11).
3. Replace a defective air filter
with a new filter (see “Spare
Parts”).
Summary of Contents for BRM 46-150 BSA InStart
