GB
62
• Take care with equipment that
has several cutting tools, as
the movement of one blade
may result in the rotation of the
other blades.
• Use only spare parts and acces
-
sories supplied and recommend
-
ed by the manufacturer. The use
of non-original parts will immedi
-
ately invalidate the guarantee.
• Prior to use, always check the
cord and extension cord for
signs of damage or wear. Im
-
mediately disconnect the cord
from the mains in case it is
damaged in use. Do not touch
the cord until it is unplugged.
Do not operate the appliance if
the cord is worn or damaged.
Working with the Equipment:
Do not place feet or hands
near or under rotating parts
when working. Risk of injury!
Observe the noise protec-
tion and local regulations.
• Switch on the motor accord
-
ing to the instructions and only
when your feet are at a safe
distance from the cutting tools.
• Do not use the equipment in
the rain, in poor weather, in a
damp environment, or on wet
grass. Work only in daylight or
with good lighting.
• Do not work with the equipment
when tired, lacking concentra
-
tion or under the influence of
alcohol or drugs. Always take
breaks in good time. Take a
sensible approach to the work.
• When working, ensure a firm
stance, particularly on slopes.
Always work across the slope,
never upwards or downwards.
Take particular care when
changing the direction of travel
on the slope. Do not work on
excessively steep slopes.
• Run the equipment only at a
walking pace. Take particular
care when turning the equip
-
ment around, pulling it towards
you or going backwards.
• Switch on the equipment care
-
fully and in accordance with
the directions in these instruc-
tions. Ensure sufficient distance
between feet and the rotating
blades.
• Do not tilt the unit when start-
ing it up, unless this is required
when starting up in long grass.
In this case, tilt the device only
slightly to the side using the
bow-type handle. Always check
that both hands are in the work-
ing position before returning the
equipment to the ground.
Caution! Danger! The blade
continues to run after switch-
ing off.
There is a risk of injury.
• The equipment is not to be
lifted or transported while the
motor is running. Switch off the
equipment if it has to be tilted in
transit, when crossing surfaces
other than grass, and when the
equipment is being transported
to and from the surfaces to be
mowed.
Summary of Contents for ERM 1600-34 L
