14
increase safety and accuracy for specialized
entioned in this manual that can be built to
moulder. There are mang different jips not m-
to maximize the potential of your spindle
books,trade magazines, or get formal training
WE STRONGLY RECOMMEND that you read
SECTION 4: OPERATIONS
Test Run
To test run the machine:
1.
Connect the machine to the power source.
2.
Make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is setup properly.
3.
Make sure all tools and objects used during
set up are cleared away from the machine.
4.
Press the START button to turn the machine
ON
.
5.
Check to make sure the spindle is rotating in
a counterclockwise direction when the switch
is in the FORWARD position.
6.
Listen to and watch for abnormal noises or
actions. The machine should run smoothly
with little or no vibration or rubbing noises.
— Immediately turn the shaper
OFF
if you
suspect any problems and fix any prob-
lems before starting the shaper again.
Wear safety glasses dur-
ing the entire operation
process. Failure to com-
ply may result in serious
personal injury.
Disconnect power to the
machine when perform-
ing any maintenance or
assembly. Failure to do
this may result in serious
personal injury.
NOTICE
The following section was designed to give
instructions on the basic operations of this
shaper. However, it is in no way compre-
Always wear a dust
mask when operating
this shaper. Using this
machine produces saw-
dust that may cause short
and long-term respira-
tory illness.
Keep loose clothing out
of the way of machin-
ery and keep hair pulled
back during operations.
hensive of every spindle moulder application.
cuts.
Summary of Contents for G1026
