t20568 1
1
⁄
4
" brad nailer
-6
-
compressed air
system
the model t20568 is designed to be oper-
ated at 60-100 pSi using clean, dry, regu-
lated, compressed air.
do not exceed
the 120 psi maximum operating pres-
sure for your model.
before using your new nailer, regulate the
air pressure on your air compressor to the
minimum pSi for your model.
an in-line filter/lubricator/regulator unit,
depicted in
figure 2, can be installed and
should be located as close to the nailer
as possible.
this filter/lubricator/regulator unit will pro-
tect your tool from damaging water build-
up, allow you to adjust and maintain con-
stant air pressure to your tool, and save
you the inconvenience of manually lubri-
cating your tool every time you use it.
Quick
Connector
Quick
Coupler
Air Hose
Quick
Coupler
Quick
Connector
Lubricator
Filter
Regulator
Air
Compressor
Your
Tool
figure 2. typical filter/lubricator/regulator installation order.
Check the current grizzly catalog for avail-
ability of this unit. if you plan on install-
ing a filter/lubricator/regulator unit in your
compressed air system, always follow the
connection instructions that come with
the unit.
exceeding the maximum permissible
operating pressure may cause the
nailer to explode, blowing metal frag-
ments in all directions. to protect
yourself from serious personal injury,
do not allow your air compressor to
exceed the recommended pressure
when connected to this nailer!
