-22-
Model g0443 (Mfg. since 11/09)
23. Fit the plastic canister collection bag over
the bottom of the canister filter and clamp in
place with the metal bag clamp, as shown in
figure 30.
figure 30. plastic collection bag clamped in
place under filter.
Bag
Clamp
24. Mount the switch on the funnel with the (2)
5
⁄
16
"-18 x 1" hex bolts, (4)
5
⁄
16
" flat washers,
and (2)
5
⁄
16
"-18 hex nuts (see
figure 31).
NOTICE
The Model G0443 is prewired for 110v. if
you plan to operate the machine at 220v,
the motor must be rewired (see Page 12)
and a 220v switch must be installed.
insert the plug attached to the machine power
cord into a matching power supply receptacle.
the machine is now connected to the power
source.
if you need to disconnect the machine from power
later, pull the plug completely out of the recep-
tacle.
Power Connection
Power Connection
Before the machine can be connected to the
power source, an electrical circuit and connec-
tion device must be prepared per the
POWER
SUPPLY section in this manual, and all previ-
ous setup instructions in this manual must be
complete to ensure that the machine has been
assembled and installed properly.
always make sure the power switch on the
machine is turned oFF (or the oFF button is
pushed in) before connecting power.
figure 31. Magnetic switch mounted to funnel.
x 2
