H2933/H2934/G0447/G0581 Wide Belt Sander
-17-
Site Considerations
Floor Load
Refer to the
Machine Data Sheet for the weight
and footprint specifications of your machine. Some
shop floors may require additional reinforcement
to support both the machine and operator.
Working Clearance
Working clearances can be thought of as the
distances between machines and obstacles that
allow safe operation of every machine without
limitation. Refer to the
Machine Data Sheet for
dimensions of your machine. Consider existing
and anticipated machine needs, size of material to
be processed through each machine, and space
for auxiliary stands and/or work tables. Also, con-
sider the relative position of each machine to one
another for efficient material handling. Be sure to
allow yourself sufficient room to safely run your
machines in any foreseeable operation and keep
dust collection hoses off the floor and out of the
way.
Lighting
Lighting should be bright enough to eliminate
shadows and prevent eye strain. Electrical cir-
cuits should be dedicated or large enough to
handle combined motor amp loads. Be sure to
observe local electrical codes for proper installa-
tion of new lighting or circuits.
Unsupervised children and
visitors entering a shop
could suffer serious per-
sonal injury. Ensure child
and visitor safety by keep-
ing all entrances to the
shop locked at all times.
DO NOT allow unsuper-
vised children or visitors
in the shop at any time.
Clean Up
Any unpainted surfaces are coated with a waxy
oil to protect them from corrosion during ship-
ment. Remove this protective coating with a sol-
vent cleaner or citrus-based degreaser such as
Grizzly’s G7895 Degreaser. To clean thoroughly,
some parts may need to be removed.
For opti-
mum performance from your machine, make
sure you clean all moving parts or sliding
contact surfaces that are coated. Avoid chlo-
rine-based solvents as they may damage painted
surfaces should they come in contact.
Gasoline and petroleum
products have low flash
points and could explode
if used to clean machin-
ery. DO NOT use gasoline
or petroleum products to
clean the machinery.
Lack of ventilation while
using solvents could
cause serious person-
al health risks, fire, or
environmental hazards.
Always work in a well
ventilated area to pre-
vent the accumulation
of dangerous fumes.
Supply the work area
with a constant source
of fresh air.
Summary of Contents for G0447
