Model G0449/G0450 (Mfd. Since 8/13)
-43-
8. Measure the distance between the rear and
front drum, as shown in
Figure 56, on both
sides.
11. Loosen the front drum pillow bearing lock
nuts (
Figure 55).
12. Slide the front drum against the gauge blocks
until they are snug between the front and rear
drum. This will make the front drum parallel
to the rear drum—which is parallel to the rear
frame (conveyor rollers) and perpendicular to
the feed direction.
13. Now, go to Setting Rear Drum Height &
Adjusting Drums Parallel to Conveyor Belt
on
Page 44.
14. Tighten the front drum pillow bearing lock
nuts.
Figure 57. Example of small gauge block
positioned between front and rear drums.
— If the difference between the two measure-
ments at each end is equal or less than
1
⁄
8
", skip to
Step 13.
— If the difference between the two measure-
ments at each end is more than
1
⁄
8
", con-
tinue to the next step.
9. Make two gauge blocks the same width as
your measurement in
Step 8.
10. Place the small gauge blocks on each end
of the pressure roller between both drums as
shown in
Figure 57.
Figure 56. Measuring distance between rear and
front drums.
Gauge
Blocks
Summary of Contents for G0449
Page 80: ......
