-28-
Model g0493 (Mfg. since 7/10)
19. attach the support brace and dust collection
hose support to the table with five M10-1.5 x
30 cap screws and 10mm lock washers, as
shown in
figure 35.
figure 36. attaching the scale bar.
Scale Bar
Hex Bolt
Hex Nut
Lock Washer
Flat Washer
Table
20. Mount the scale bar to the cast iron table and
large extension table, making sure it is even
with the top of the tables. use the three M6-1
x 25 hex bolts, three 6mm flat washers, three
6mm lock washers, and three M6-1 hex nuts,
as shown in
figure 36, to mount it. (the top
of the hex bolts slide into the scale bar.)
22. insert the studs into the tables as shown in
figure 38. put a 12mm flat washer, 12mm
lock washer and a M12-1.75 hex nut on the
end of each stud to hold the round rail on
the tables. do not tighten the hex nuts at this
time.
figure 38. installing the round rail.
21. the fence rail is pre-assembled with four rail
studs and accompanying hardware. remove
one hex nut, flat washer, and lock washer
from the end of each stud, as shown in
figure 37.
figure 37. hardware removed from fence rail
studs to prepare for installation.
figure 35. dust collection hose support
installation.
dust Collection
hose support
support Brace
