-16-
G0508 10 HP Industrial Dust Collector
Once assembly is complete, test run your machine
to make sure it runs properly.
To test run the dust collector:
1.
Make sure you have read and understand all
of the safety instructions starting on
Page 6
of this manual, and make sure the machine is
set up properly.
2.
Connect the dust collector to the proper power
source (reference
Circuit Requirements
on
Page 9
).
3.
Clear away from the machine all tools and
objects used during the setup.
4.
Turn the machine
ON
by pushing in the
GREEN button on the power switch.
5.
Listen and watch for abnormal noises or
operation. The machine should run smoothly
with little or no vibration or rubbing noises.
— Strange or unusual noises MUST be inves-
tigated and corrected before operating the
machine further. Always disconnect the
machine from power before investigating
or correcting potential problems.
—If you cannot easily locate the source of a
potential problem, refer to
Troubleshooting
on
Page 30
or contact our Technical
Support at (570) 546-9663.
6.
Turn
OFF
the machine by pushing in the RED
button on the power switch.
Test Run
Wear safety glasses
whenever starting or
using machine. Failure
to comply may result in
serious personal injury.
Keep loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
Do NOT put hands or
small objects near inlet
openings during opera-
tion. Objects sucked
into the inlet will meet
with the impeller blade.
Failure to heed this
warning could result in
property damage or per-
sonal injury.
Summary of Contents for G0508
