-16-
g0529 oscillating Spindle & disc Sander
figure 16
. dust port locations.
dust collection
miter gauge
there are two 2" dust collection ports for the
sander that should be connected to a dust collec-
tor. the ports are located under the sanding
tables as shown in
figure 15
.
figure 15
. Squaring miter gauge to disc.
the miter gauge needs to be adjusted perpen-
dicular to the face of the wheel when it is mounted
in the table slot.
to adjust miter gauge:
1.
use a machinist square with one edge
against the face of the miter gauge and the
other against the disc face as shown in
figure 14.
2" dust ports
2.
loosen the lock knob on the miter gauge to
adjust it flush with the edge of the square.
3.
tighten the lock knob, and verify the setting.
note—
Sometimes the tightening procedure
can affect the adjustment.
4.
loosen the setscrew that secures the angle
pointer and adjust the pointer to the 0˚ mark
on the scale.
5
. retighten the setscrew that secures the
angle pointer.
to connect your machine to a dust collection
system:
1.
use a 2" diameter hose to connect a dust
collection system to your dust ports.
2.
Start the dust collection system before oper-
ating the sander.
