Copyright © june, 2008 By grizzly industrial, inC.
Warning: no portion of this manual may be reproduced in any shape
or form Without the Written approval of grizzly industrial, inc.
#Bl10818 printed in taiWan
the Model g0636XB is the same as the Model g0636X, except it has a magnetic brake motor and a square
fence rail. Besides the instructions, data sheet, circuit requirements, parts, and wiring diagram in this insert,
the content in the Model g0636X owner's manual is the same for both machines. Before operating your
new machine, you Must read and understand this insert and the entire Model g0636X manual to reduce
the risk of injury from improper use or setup.
If you have any further questions about this manual insert or the differences between the Model
g0636XB
and the Model
g0636X
, contact our Technical Support at (570) 546-9663 or email techsupport@grizzly.
com.
model g0636Xb
ultimate 17" bandsaW
w/motor braKe
manual insert
machine inventory
after all the parts have been removed from the
crate, you should have the following items:
crate contents (figure 1):
Qty
a. Bandsaw (not shown) ................................. 1
b. Miter gauge ................................................ 1
c. Fence.......................................................... 1
d. resaw Fence ............................................. 1
e. guide post handwheel............................... 1
figure 1. g0636XB inventory.
B
C
e
d
hardware and tools (not shown)
Qty
hex Wrench 5mm .............................................. 1
hex Wrench 6mm .............................................. 1
open end Wrench 10 x 13 ................................ 1
open end Wrench 17 x 19 ................................ 1
lifting rings ....................................................... 2
resaw Fence lock handle M8-1.25 x 44
(resaw Fence) .................................................. 1
Moving plate (resaw Fence) ............................ 1
Flat Washer 8mm (resaw Fence) .................... 1
installing fence
components and hardware needed:
Qty
Fence assembly ................................................ 1
resaw Fence assembly .................................... 1
resaw Fence lock handle M8-1.25 x 44 ......... 1
Moving plate ...................................................... 1
Flat Washer 8mm .............................................. 1
to install the fence:
1. remove the cap screw, knobs, and washers
that hold the rail onto the table, then remove
the rail.
2. Flip the rail over and reinstall with the fast-
ners removed in
step 1.
3. install the fence handle on the fence, if it is
not already installed.
