g0648 Welding Fume Extractor
-29-
vibrating Filter
(
Manual Cleaning
)
the vibrating filter collects 85% of the 1-micron
particles. this filter rarely needs to be replaced
if the machine is used properly and the filter is
periodically removed and manually cleaned.
Tools Needed
Qty
Wrench 17mm.................................................... 1
Wrench 14mm ................................................... 1
oSha approved respirator .............................. 1
Safety goggles .................................................. 1
air Compressor ................................................. 1
Blowgun ............................................................. 1
To perform this procedure:
1.
With the machine plugged in, press the
manual cleaning mode and hold for a few
seconds. the vibrating filter motor will operate,
cleaning the vibrating filters.
2.
diSConnECt thE MaChinE FroM
poWEr, put on your respirator and safety
goggles.
3.
unlatch the hEpa filter housing, open the
housing, and lift the hEpa filter up and out of
the housing (
Figure 33
).
Figure 33.
removing hEpa filter housing.
latch
5.
using the 17mm wrench or a socket wrench,
remove the right-side spring retaining bolt
from the cabinet (
Figure 33
).
6.
reach into the cabinet, firmly grasp the
right-side compression spring, and remove
the spring (
Figure 35
). the spring is under
tension, so make sure you do not lose your
grip while you work the spring out of the
cabinet.
Figure 34.
Vibrating filter retainer.
Cap
Jam nut
Spring
retaining
Bolt
Figure 35.
Vibration motor access.
Spring
retaining
Bolt
4.
remove the plastic caps and loosen both jam
nuts until they park against the underside of
the spring retaining bolt heads (
Figure 34
).
7.
repeat
Steps
4
–
6
on the left-hand retaining
bolt and spring.
