-20-
Model g0661/g0713 (Mfg. since 1/10)
Inventory
the following is a list of the main components
shipped with the Model g0661/g0713. lay the
components out to inventory them.
Note:
If you can't find an item, check the mounting
location on the machine or examine the packag-
ing materials carefully. Occasionally we pre-install
certain components for shipping.
Box Contents (Figures 9–11):
Qty
A. table saw unit (not shown) ....................... 1
B. right stand legs ........................................ 2
C. left stand legs .......................................... 2
D. Extension Wings ......................................... 2
E. Feet ............................................................ 4
F. upper stand Braces ................................... 2
G. side stand Braces ..................................... 2
h. lower stand Braces ................................... 2
I. Motor Cover ................................................ 1
J. spreader/Blade guard assembly ............... 1
K. table tilt handwheel ................................. 1
L. handle ........................................................ 1
M. dado table insert ....................................... 1
N. Miter gauge assembly ............................... 1
O. arbor Wrenches ......................................... 2
p. Wrench 11/13mm ....................................... 1
Q. hex Wrench 2.5, 5, 6mm ..................1 Each
R. push stick .................................................. 1
S. switch disabling lock ................................ 1
T. Front rail rectangular tube ...................... 1
u. Front rail 66" ............................................. 1
V. rear rail 60
3
⁄
4
" ........................................... 1
W. Fence assembly ......................................... 1
X. Fence lock Knob ....................................... 1
y. Blade 10" .................................................... 1
hardware (Not Shown):
Qty
Key 4 x 4 x 10mm (handwheel) ........................ 1
set screw M5-.8 x 6 (handwheel) .................... 1
hex Bolts M8-1.25 x 20 (Wings) ....................... 8
lock Washers 8mm (Wings) ............................. 8
Carriage Bolts M8-1.25 x 12 (stand) .............. 28
Flat Washers 8mm (stand/Feet) ..................... 36
hex nuts M8-1.25 (stand/Feet) ...................... 36
hex Bolts M6-1 x 12 (switch) ............................ 2
Flat head screws M8-1.25 x 25 (Fence) .......... 6
lock Washers 8mm (Fence) ............................. 6
hex nuts M8-1.25 (Fence) ................................ 6
Flange Cap screws M8-1.25 x 25 (Fence) ....... 6
Figure 9. inventory contents B–h.
Figure 10. inventory contents i–s.
Figure 11. inventory contents t–y.
B
C
d
E
F
g
h
i
j
K
l
M
n
o
p
Q
r
t
s
u
V
X
y
W
hex nuts M8-1.25 (Fence) ................................ 6
Flange Bolts M8-1.25 x 10 (Fence) ................... 6
Flat Washers 8mm (Fence) ............................... 6
lock Knob M5-.8 (insert) ................................... 1
