Model G0671/G0672/G0673 (Mfd. Since 6/17)
-21-
Contents (Figures 5–7)
Qty
A. Collectors ................................................... 4
B. 5-in-1 Inlet Adapter ..................................... 1
C. G0673 Impeller Housing with Motor ........... 1
D. Legs ............................................................ 4
E. Leg Braces ................................................. 4
F. Combo Wrench 10 x 12mm ........................ 1
G. Casters ....................................................... 4
H. Upper Filter Bags (Fabric) .......................... 4
I. Lower Collection Bags (Plastic) .................. 4
J. Hangers ...................................................... 4
K. Hanger Supports ........................................ 4
L. Rubber Gaskets ......................................... 4
M. Bag Clamps ................................................ 8
Fasteners (where used) (not shown)
Qty
•
Hex Bolts
5
⁄
16
"-18 x 2
1
⁄
2
" (legs) .................... 8
•
Hex Nuts
5
⁄
16
"-18" (legs/collectors) ............ 40
•
Hex Bolts
5
⁄
16
"-18 x
1
⁄
2
" (leg braces) .......... 16
•
Hex Bolts
5
⁄
16
"-18 x 1" (collectors) ............. 32
•
Hex Bolts
1
⁄
4
"-20 x
1
⁄
2
" (hangers) ............... 12
•
Flat Washers
5
⁄
16
" (collectors) ................... 64
•
Phillips Head Screw 10-24 X
3
⁄
8
" (inlet) ...... 1
Figure 5. G0673 Inventory 1.
A
B
C
D
E
F
H
I
J
Figure 6. G0673 Inventory 2.
K
L
M
Figure 7. G0673 Inventory 3.
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
G0673 Inventory
G
