-56-
Model G0690/G0691 (Mfd. 6/15+)
Using the Auxiliary Fence and Push
Block
1. Place the auxiliary fence on the table and
clamp it to the fence at both ends, then adjust
the distance between the auxiliary fence and
the blade—this determines how wide the
workpiece will be ripped (see
Figure 86).
2. Install the blade guard, then secure the
spreader pawls in the upright position, as
shown in
Figure 51 on Page 38, so they do
not interfere with the push block lip.
Workpiece
Cutting Width
Blade
Auxilliary Fence
Figure 86. Adjusting ripping distance between
blade and auxiliary fence.
Keep the blade guard installed and in the
down position. Failure to do this could
result in serious personal injury or death.
Turn OFF the saw and allow the blade to
come to a complete stop before removing
the cut-off piece. Failure to follow this warn-
ing could result in serious personal injury.
Auxilliary Fence
Blade
Workpiece
Push Stick
for Side
Support
Blade Path
Push
Block
Figure 87. Push block in position to push
workpiece through blade.
3. Place the workpiece 1" behind the blade and
evenly against the table and the auxiliary
fence.
4. Turn the saw ON, then begin ripping the
workpiece using a push stick for side support.
5. As the workpiece nears the end of the cut,
place the push block on the auxiliary fence
with the lip directly behind the workpiece,
then release the push stick just before the
blade.
6. Guide the workpiece the rest of the way
through the cut with the push block, as shown
in
Figure 88.
Push
Block
Lip
Release
Push Stick
Before Blade
Blade Path
Figure 88. Ripping with push block.
Summary of Contents for G0690
Page 20: ...18 Model G0690 G0691 Mfd 6 15 Hardware Recognition Chart...
Page 92: ......
