Model G0690/G0691 (Mfd. 6/15+)
-69-
3. Loosen the two cap screws on the mount-
ing block, then adjust either the top or bot-
tom control set screws or side control set
screws (see
Figure 115) to move it the
needed direction.
Adjusting Bent Spreader/Riving
Knife
1. DISCONNECT THE SAW FROM POWER!
2. Bend the spreader or riving knife by hand
while installed, then follow
Steps 1–3 in
Checking Alignment to determine if it is par-
allel with the blade and inside the "Alignment
Zone" (refer to
Checking Alignment).
— If this doesn't work, remove it to straighten.
— If you cannot straighten it properly, replace
it.
4. Reinstall the table insert.
5. Follow Checking Alignment, Steps 1–3.
— If the spreader/riving knife is in the alignment
zone, no additional steps are necessary.
—If the spreader/riving knife is still not in the
alignment zone, continue adjusting the set
screws on the mounting block as neces-
sary to correctly position the spreader/
riving knife.
6. Tighten the two cap screws on the mount-
ing block to secure the spreader/riving knife
adjustment.
Fence Adjustments
There are four main adjustments for the fence:
square, height, parallelism, and clamping pres-
sure. Keep in mind that these adjustments are
interconnected and some trial-and-error may be
needed to achieve satisfactory results.
Tools Needed
Qty
Hex Wrench 6mm .............................................. 1
Square ............................................................... 1
Felt-Tipped Marker ............................................ 1
Square and Height
The fence face must be square to the table in
order to produce square cuts. Also, the fence
should be adjusted high enough off the table that
it does not drag across the surface.
Top and Bottom Control: To move the top
of the spreader/riving knife right or left (and
the bottom of the spreader/riving knife in the
opposite direction), adjust the top and bottom
pair of set screws on the mounting block an
equal amount in the opposite direction.
Side Control: To move the front of the
spreader/riving knife left or right (and the rear
of the spreader/riving knife in the opposite
direction), adjust each pair of side control
set screws an equal amount in the opposite
direction.
Note: To adjust how tightly the mounting
block holds the spreader/riving knife, adjust
the center screw.
Figure 115. Set screws for adjusting spreader/
riving knife position.
Alignment
Zone
Misaligned
Splitter or
Riving Knife
Blade
Adjustment Block
Top Control
Side
Control
Side
Control
Bottom Control
Cap
Screws
Set Screw
Center
Screw
Cap
Screws
Summary of Contents for G0690
Page 20: ...18 Model G0690 G0691 Mfd 6 15 Hardware Recognition Chart...
Page 92: ......
