"'%"
BdYZa<%+.-B[\#h^cXZ&%$%.
Adjusting Headstock
I]Z BdYZa <%+.- ]ZVYhidX` ^h Zfj^eeZY l^i] V
XVb"VXi^dc XaVbe^c\ hnhiZb id hZXjgZ ^i id i]Z
aVi]ZWZY#L]Zci]ZaZkZg^hi^\]iZcZY!VadX`^c\
eaViZa^[ihjejcYZgcZVi]i]ZWZYVcYhZXjgZhi]Z
iV^ahidX` ^c eaVXZ# I]Z ]ZVYhidX` XVc WZ edh^"
i^dcZYVcnl]ZgZVadc\i]ZaVi]ZWZY#
To position the headstock along the length of
the lathe bed:
1.
9>H8DCC:8IA6I=:;GDBEDL:G
2.
AddhZc i]Z ]ZVYhidX` adX` ]VcYaZ hZZ
Figure 18
#
Figure 18.
=ZVYhidX`adX`]VcYaZ#
3.
Ha^YZi]Z]ZVYhidX`idi]ZYZh^gZYadXVi^dcdc
i]ZWZYVcYjhZi]Z]ZVYhidX`adX`]VcYaZid
hZXjgZi]Z]ZVYhidX`^cedh^i^dc#
Note:
The large clamping hex nut under-
neath the headstock will require occasional
adjusting to ensure proper clamping pressure
of the headstock to the bed. Turn this hex nut
in small increments to fine tune the clamping
pressure as needed.
Always operate the lathe with the headstock
firmly locked to the bed. Otherwise, serious
personal injury may occur.
Adjusting Tailstock
I]Z iV^ahidX` ^h Zfj^eeZY l^i] V XVb"VXi^dc
XaVbe^c\ hnhiZb id hZXjgZ ^i id i]Z aVi]Z WZY#
L]Zc i]Z aZkZg ^h i^\]iZcZY! V adX`^c\ eaViZ a^[ih
jejcYZgcZVi]i]ZWZYVcYhZXjgZhi]ZiV^ahidX`
^ceaVXZ#
To position the tailstock along the length of
the bed:
1.
AddhZc i]Z iV^ahidX` adX` ]VcYaZ VcY bdkZ
i]ZiV^ahidX`idi]ZYZh^gZYedh^i^dcVadc\i]Z
WZYhZZ
Figure 19
#
Figure 19.
IV^ahidX`adX`]VcYaZ#
2.
GZ"Zc\V\Zi]ZiV^ahidX`adX`]VcYaZidhZXjgZ
i]ZiV^ahidX`idi]ZWZY#
Note:
The large clamping hex nut under-
neath the tailstock will require occasional
adjusting to ensure proper clamping pressure
of the tailstock to the bed. Turn this hex nut
in small increments to fine tune the clamping
pressure as needed.
Always operate the lathe with the tailstock
firmly locked to the bed. Otherwise, serious
personal injury may occur.
