Model G0746/G0749 (Mfg. Since 3/13)
-61-
F
Lever
G
Dial
G
5
6
7
8
9
1
0
11
1
2
3
4
mm
˶
E
Lever
3
2
1
Selection Lever
Feed Rod (DOWN)
Leadscrew (UP)
figure 99. lever and dial settings for 1.25 Mp.
4. position the gearbox levers and dials, as
shown in
figure 99.
3. to the left of 1.25 Mp, locate the f lever in
the left position, and
G dial in the 4 position.
above 1.25 Mp, locate the
E lever in the 2
position (see
figure 98).
Note:
In the next step, rock the chuck back
and forth so the gears will mesh together.
figure 98. 16 tpi and corresponding lever and
dial positions.
2. locate 1.25 Mp on the chart below.
lever & dial
positions
g dial
position
F lever
position
1.25 Mp
5. Move the leadscrew feed rod selection lever
up.
the lathe is now set up to turn 1.25 Mp.
selection
lever
E lever
position
E lever position
F lever
position
g dial
position
