Model G0768/G0769 (Mfd. Since 8/15)
-65-
Installing/Removing
Tooling
Cutting tools are sharp and
can easily cause cutting
injuries. Always protect
your hands with leather
gloves or shop rags when
handling cutting tools.
The Model G0769 includes a
1
⁄
2
" drill chuck with
MT#2 arbor (see
Figure 110).
Figure 110.
1
⁄
2
" chuck joined with MT#2 arbor.
Installing Tooling
Tools Needed
Qty
Wrench 8mm ..................................................... 1
Wrench 17mm.................................................... 1
Wrench 25mm ................................................... 1
To install tooling:
1. DISCONNECT MACHINE FROM POWER!
2. Remove drawbar cap (see Figure 111).
Figure 111. Location of drawbar cap.
Drawbar Cap
3. Insert tooling into spindle until in contacts
drawbar.
4. Working from top, thread drawbar by hand
into tooling until it is snug (see
Figure 112).
Figure 112. Threading drawbar into tooling.
5. Tighten drawbar.
Note: Do not overtighten drawbar.
Overtightening makes tool removal difficult
and will damage arbor and threads.
6. Tighten drawbar lock nut, as shown in Figure
113.
7. Re-install drawbar cap.
Figure 113. Tightening drawbar lock nut.
Drawbar
Locknut
