-26-
Model G0768/G0769 (Mfd. Since 8/15)
With the exception of the handwheel handles, the
lathe is shipped fully assembled.
Use a flat head screwdriver to attach the handwheel
handles shown in
Figure 18.
Assembly
Figure 18. Handwheel handles installed.
Carriage
Handle
Cross Slide
Handle
Figure 17. Grizzly Model H2683 12" Master
Machinist's Level.
Leveling machinery helps precision components,
such as bedways, remain straight and flat dur-
ing the lifespan of the machine. The bed on a
lathe that is not level may slowly twist due to the
dynamic loads placed on the machine during
operation.
For best results, use a precision level that is at
least 12" long and sensitive enough to show a
distinct movement when a 0.003" shim (approxi-
mately the thickness of one sheet of standard
newspaper) is placed under one end of the level.
See
Figure 17 for an example of a high-precision
level.
For accurate turning results and to prevent
warping the cast iron bed and ways, the
lathe bedways MUST be leveled from side-
to-side and from front-to-back on both ends.
Recheck the bedways 24 hours after
installation, two weeks after that, and then
annually to make sure they remain level.
Leveling
