Model G0787 (Mfd. Since 09/14)
-21-
The Model G0787 Disc/Belt Sander accepts 6"
diameter cloth- or paper-backed pressure sensi-
tive adhesive (PSA) sandpaper discs. These are
available in a variety of grits through the Grizzly
catalog. See
Accessories on Page 23 for prices
and ordering information.
The PSA sandpaper discs stick directly to the
surface of the aluminum disc.
1. Peel back protective layer from one-half
of new sandpaper disc and fold it against
remaining half.
2. Center sticky half of sandpaper disc on upper
half of aluminum disc and press sandpaper
disc onto surface (see
Figure 24).
Figure 24. Installing sanding disc.
3. Remove remaining half of protective layer
from sandpaper disc, then press remaining
portion of sandpaper disc onto aluminum
disc.
4. Rotate disc by hand and check to make sure
sandpaper is firmly attached to disc without
any bumps or wrinkles.
5. Re-install disc cover and work table.
6. Check work table alignment and adjust if
necessary (see
Aligning Work Table on
Page 28).
Changing/Replacing
Sandpaper Disc
4. Remove old sandpaper disc from aluminum
disc.
1. DISCONNECT MACHINE FROM POWER!
2. Remove work table.
3. Remove (2) M4.2 x 10 tap screws and disc
cover shown in
Figure 23.
x 2
Figure 23. Removing disc cover.
Disc Cover
Removing Sandpaper Disc
Attaching Sandpaper Disc
Summary of Contents for G0787
Page 40: ......
