G0803
(Mfd. Since 09/15)
-17-
Blade Centered
on Wheel
Blade
Centered
on Wheel
PROPER TRACKING
Wheel
or
Parallel But Not
Coplanar
Parallel And
Coplanar
Coplanar But
Not Parallel
Not Coplanar or
Parallel
Figure 17. Blade centered on crown of wheel.
Figure 18. Wheel alignment and misalignment
examples.
Blade Tracking
"Tracking" refers to how the blade rides on the
bandsaw wheels. Proper tracking is important
for maintaining bandsaw adjustments, achiev-
ing correct blade tension, and cutting accurate-
ly. Improper tracking reduces cutting accuracy,
causes excess vibrations, and places stress on
the blade and other bandsaw components. The
shape of the wheels and the orientation of the
wheels in relation to each other determine how
the blade tracks.
Bandsaw wheels are either flat or crowned and
both shapes track differently. The G0803 has
crowned wheels. As the wheels spin, a properly
tracking blade naturally tracks at the center of the
wheel (see
Figure 17).
The bandsaw wheels must be aligned for optimal
machine performance. Properly aligned wheels
are parallel and coplanar (see
Figure 18).
Improper blade tension and cutting practices can
negatively affect blade tracking. Familiarizing
yourself with the ideas and conditions described
in
Figure 18 will help you recognize when your
wheel alignment may need to be adjusted (refer
to
Wheel Alignment on Page 44 for detailed
instructions on adjusting the tracking).
The wheels on the G0803 were aligned at the fac-
tory, so center tracking is the only adjustment that
needs to be performed when the saw is new. This
adjustment is necessary before turning the saw
on or performing other adjustments.
Summary of Contents for G0803
Page 56: ...54 G0803 Mfd Since 09 15...
Page 60: ......
