Model G0803Z (Mfd. Since 12/18)
-23-
3. Position support bearing approximately 0.016"
away from the back of the blade, as illustrated
in
Figure 24. This can be measured with a
feeler gauge.
Note: The main purpose of this adjustment
is to prevent the blade from being pushed
backward far enough that the blade guides
will contact (and ruin) the "tooth set" of the
blade during cutting operations.
0.016''
Figure 24. Bearing positioned 0.016" away from
back of blade.
4. Tighten adjustment cap screw to lock support
bearing in place.
Note: When securing adjustment of lower
support bearing, make sure it is parallel to
blade.
Adjusting Blade
Guide Bearings
The blade guide bearings can be adjusted left-
to-right, as well as front-to-back, relative to the
blade. Properly adjusted blade guide bearings
provide side-to-side support, from just behind the
gullets to the back of the blade, to help keep the
blade straight while cutting.
There are blade guide bearings on the upper and
lower blade guide assemblies. Both adjust in the
same manner. The following instructions refer to
the upper guide bearings.
Important: Make sure the blade is tracking and
tensioned correctly before performing this proce-
dure (see
Tensioning Blade on Page 21).
Item(s) Needed
Qty
Hex Wrench 4mm .............................................. 1
To adjust blade guides:
1. DISCONNECT MACHINE FROM POWER!
2. Loosen guide block cap screw shown in
Figure 25, then laterally position guide bear-
ings just behind blade gullets, as illustrated
in
Figure 26, then re-tighten cap screw to
secure setting.
Note: The guide bearings should be posi-
tioned behind the gullets a distance equal to
that of the support bearing behind the blade
(see
Page 22 for reference).
Figure 25. Upper guide bearing components.
Guide Bearing
Adjustment
Cap Screw
(1 of 2)
Guide Bearing
(1 of 2)
Guide Block
Cap Screw
Summary of Contents for G0803Z
Page 60: ......
