Model G0812 (Mfd. Since 2/16)
-19-
2. Slide work stop rod into hole in vise base so
scale faces up and rod is flush with back of
vise bed casting (see
Figures 14–15), then
tighten front and rear set screws.
Note: The stop rod can be installed on either
side of the vise base depending upon the
cutting operation. It should be placed on the
same side where the workpiece is being cut.
Refer to
Work Stop on Page 32 for additional
details.
3. Slide work stop arm onto stop rod, posi-
tion it as necessary, then tighten cap screw
(see
Figure 16).
4. Insert work stop into arm and secure with
knob (see
Figure 16).
5. Fit splash guard over lip of base, as shown in
Figure 17.
Figure 14. Work stop arm attached to stop rod.
Figure 15. Stop rod flush with vise base casting.
Figure 16. Work stop attached to work stop arm.
Figure 17. Splash guard installed over lip of
base.
Splash
Guard
Lip
Scale
Stop Rod
Work Stop
Arm
Knob
Work Stop
Arm
Cap Screw
Work Stop
Work Stop
Rod
Summary of Contents for G0812
Page 84: ......
