Model G0818 (Mfd. Since 10/16)
-25-
SECTION 6: MAINTENANCE
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
Daily Check
•
Loose mounting bolts.
•
Check/empty dust collection drawer and dust
tray.
•
Check/replace filters.
•
Worn or damaged wires.
•
Any other unsafe condition.
Monthly Check
•
Clean dust buildup from inside cabinet and
off motor. Inspect and clean inside ducts.
Every 10–15 Hours
•
Clean stainless steel mesh filter. Inspect for
damage and replace if necessary.
Every 25–30 Hours
•
Clean active carbon filter.
Every 35–40 Hours
•
Clean pleated micro filter.
Every 300 Hours
•
Replace active carbon filter and pleated
micro filter every 300 hours of use, or sooner
if cleaning filters no longer improves airflow.
See
Page 27
for air filter cleaning instructions.
Schedule
Cleaning Collection
Drawer & Dust Tray
Frequently monitor and empty collection drawer
and air filter dust tray during operations (see
Figure 35
). Wear NIOSH-approved respirator,
ANSI-approved safety goggles, and leather gloves
when inspecting or emptying drawer or tray.
Cleaning Exterior
To clean the exterior of the Model G0818, wipe off
dust with a dry cloth.
To reduce risk of shock or
accidental startup, always
disconnect machine from
power before adjustments,
maintenance, or service.
Wear ANSI-approved safety goggles,
a NIOSH-approved respirator, and leath-
er gloves when removing, cleaning, and
replacing filters. Carefully minimize amount
of dust allowed to become airborne, and
prevent spread of dust onto hands or cloth-
ing. Dispose of all waste properly according
to local regulations for material type.
Figure 35.
Collection drawer and
air filter dust tray.
Dust Tray
Collection Drawer
Summary of Contents for G0818
Page 15: ...Model G0818 Mfd Since 10 16 13 5mm Hardware Recognition Chart ...
Page 40: ......
