Model G0843P (Mfd. Since 11/17)
-15-
SECTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To complete a typical sanding operation, the
operator does the following:
1.
Examines workpiece to make sure it is suit-
able for sanding.
2.
Adjusts table tilt as necessary and locks table
in place.
3.
If necessary, inserts miter gauge in miter
slot, adjusts miter gauge to required sanding
angle, and locks it in place.
4.
Puts on safety glasses and a respirator.
5.
Starts machine and dust collector.
6.
Holds workpiece firmly and flatly against
both table and miter gauge (if used), pushes
workpiece into and moves it along downward
spinning side of sanding disc.
7.
Stops machine.
To reduce your risk of
serious injury, read this
entire manual BEFORE
using machine.
To reduce risk of eye injury from flying
chips or lung damage from breathing dust,
always wear safety glasses and a respirator
when operating this machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
