-20-
Model G0844 (Mfd. Since 2/18)
Removing Headstock Center
1. DISCONNECT MACHINE FROM POWER!
2. Hold a clean rag under spindle or wear leath-
er glove to catch center when you remove it.
3. Insert knockout rod through outboard end of
spindle and firmly tap back of center, catch-
ing it as it falls, as shown in
Figure 16.
Figure 16. Example of removing headstock
center with knockout rod.
Installing/Removing
Headstock Center
The included spur center installs in the headstock
spindle with an MT#2 tapered fit.
3. Insert tapered end of center into spindle, and
push it in with a quick, firm motion, as shown
in
Figure 15.
4. Make sure center is securely installed by
attempting to pull it out by hand. A properly
installed center will not pull out easily.
Installing Headstock Center
1. DISCONNECT MACHINE FROM POWER!
2. Make sure mating surfaces of center and
spindle are free of debris and oily substances
before inserting center to ensure a good fit
and reduce runout.
Items Needed
Qty
Leather Glove/Clean Rag .................................. 1
Knockout Rod .................................................... 1
Knockout Rod
Figure 15. Example of installing center in
headstock spindle.
Spur
Center
Summary of Contents for G0844
Page 48: ......