-16-
Model G0850 (Mfd. Since 01/19)
Assembly
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to
Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
To assemble machine:
1. Attach (3) 3" non-locking swivel casters to
base stand using (12)
1
⁄
4
"-20 x
3
⁄
4
" hex bolts
and (12)
1
⁄
4
" flat washers (see
Figure 10).
Tip: Applying thread-locking fluid to bolt
threads ensures life-long tight mounting.
3. Position lower front legs in base stand with
flanges facing inside and two threaded bolt
holes above (see
Figure 12).
Figure 10. Non-locking swivel casters installed
on base stand.
x 12
2. Attach (2) 3" locking swivel casters to base
stand using (8)
1
⁄
4
"-20 x
3
⁄
4
" hex bolts and (8)
1
⁄
4
" flat washers (see
Figure 11).
Figure 11. Locking swivel casters installed on
base stand.
x 8
Figure 12. Left and right lower front legs
positioned properly in base stand.
4. Secure left and right lower front legs to base
stand with (2)
5
⁄
16
"-18 x
3
⁄
4
" hex bolts and (2)
5
⁄
16
" fender washers per leg (see
Figure 13).
Finger-tighten for now.
Figure 13. Left and right lower front legs
attached to base stand.
x 4
Right Leg
Left Leg
Right Leg
Left Leg
FRONT
Bolt
Holes
Above
Flange
Flanges
Face
Inside
Summary of Contents for G0850
Page 56: ......
