Model G0853 (Mfd. Since 07/18)
-35-
41. Locate T-bolt at end of crosscut fence exten-
sion and install fence clamp assembly, as
shown in
Figure 46.
35. Slowly roll crosscut fence face up, and guide
T-bolts aligned in
Steps 32c & 33b into their
respective hole/slot.
36. From underneath left side of crosscut fence,
thread pivot lock knob into T-bolt in pivot
hole, as shown in
Figure 44.
37. From underneath middle of crosscut fence,
position M8-1.25 T-slot plate in angle scale
bar slot, then thread angle scale bar lock
knob and 8mm fender washer onto T-slot
bolt, as shown in
Figure 44.
38. On right side of crosscut fence, ensure 0°
stop block is up against stop bolt (see
Figure
44), then rotate latch into catch and secure by
tightening knurled thumb knob.
Note: The stop bolt is set at the factory and
does not need to be adjusted.
39. Slide out crosscut fence extension approxi-
mately 6", as shown in
Figure 45.
40. Insert (2) flip stops into T-slot on fence and
tighten knob bolts to secure (see
Figure 45).
Figure 45. Flip stops installed on crosscut fence.
Fence
Extension
Flip Stop
(1 of 2)
Knob Bolt
Figure 46. Installing clamp assembly on crosscut
fence extension.
T-bolt
Crosscut
Fence
Fence
Extension
Figure 44. Crosscut fence secured to table.
Thumb Knob
Angle Scale
Lock Knob
Pivot Lock
Knob
Summary of Contents for G0853
Page 24: ...22 Model G0853 Mfd Since 07 18 5mm Hardware Recognition Chart...
Page 140: ......
