Model G0853 (Mfd. Since 07/18)
-37-
49. Loosen pre-installed hex bolt shown in Figure
51, and slide middle guard arm into middle
guard arm post. Hand-tighten hex bolt for
now.
Figure 52. Installing 4" dust port in middle guard
arm.
x 2
4" Dust Port
50. Remove (2) pre-installed button head cap
screws, lock washers, and flat washers from
4" dust port, and install dust port in end of
middle guard arm (see
Figure 52).
51. Use (3) M6-1 x 20 cap screws, 6mm lock
washers, and 6mm flat washers to attach
blade guard cover to middle guard arm (see
Figure 53).
52. Use (2) M6-1 x 12 button head cap screws
and 6mm lock washers to attach 3" dust port
to middle guard arm (see
Figure 54).
Figure 54. Installing 3" dust port on middle
guard arm.
x 2
3" Dust Port
Figure 51. Installing middle guard arm in middle
guard arm post.
Middle Guard Arm
Upper Guard
Arm Post
Hex Bolt
Figure 53. Blade guard cover attached to middle
guard arm.
x 3
Blade Guard
Cover
Summary of Contents for G0853
Page 24: ...22 Model G0853 Mfd Since 07 18 5mm Hardware Recognition Chart...
Page 140: ......
