-64-
Model G0853 (Mfd. Since 07/18)
F1
F2
F3
F4
F5
PROG.
CAL.
START
mm
inch
STOP
+
-
x
-
4
1
2
7
0
M+
CE
M-
3
6
5
8
9
Incremental
Dimension
L
50 . 0
mm
. 0
mm
600
Figure 124. Incremental Dimension screen.
IMPORTANT: Machine does NOT automati-
cally set blade height or tilt. This must be
done manually using blade controls on con-
trol panel before cut is made.
7. Load workpiece onto table.
8. Take all safety precautions, turn blades ON,
and make first cut.
9. Turn motors OFF, allow blades to come to a
complete stop, and remove workpiece from
table.
10. Press START key. Rip fence will automati-
cally move by amount entered in
Step 6.
11. Repeat Steps 7–10 until operation is com-
plete. F1 key may be pressed at any time to
end operation and return to main screen.
5. Press F2 key, enter desired rip fence starting
position, then press START key (see
Figure
124). Rip fence will move to this position.
6. Press F3 key, enter desired width of each
subsequent cut, then press START key (see
Figure 124).
Note: Positive numbers move fence away
from blade; negative numbers move fence
toward blade.
4. Press Incremental Dimension key (see
Figure 123). START key will illuminate.
Making Incremental Cuts
The rip fence can be programmed to move a spe-
cific distance from the blade to make repeat cuts
fast and simple.
To make incremental cuts:
1. Press Tool-Box key, and use F2 or F3 keys
to scroll to dimensions for blade to be used in
operation. If blade dimensions have not been
entered, enter them now (refer to
Adding/
Deleting Blade Dimensions on Page 52).
2. Press F1 to save selection and return to main
screen.
3. Ensure rip fence is calibrated for blade width
and fence face (narrow or wide) to be used in
operation (refer to
Calibrating Rip Fence on
Page 98).
Figure 123. Location of Incremental Dimension
key.
F1
F2
F3
F4
F5
PROG.
CAL.
START
mm
inch
STOP
+
-
x
-
4
1
2
7
0
M+
CE
M-
3
6
5
8
9
11. Take all safety precautions, turn blades ON,
and make first cut.
12. Turn motors OFF, allow blades to come to a
complete stop, and remove workpiece from
table.
13. Press START key. Rip fence will automati-
cally move to next position to continue groov-
ing operation, and number of cuts shown in
lower left-hand corner will be reduced by one.
14. Repeat Steps 10–13 until operation is com-
plete. START key will no longer be illuminated.
Summary of Contents for G0853
Page 24: ...22 Model G0853 Mfd Since 07 18 5mm Hardware Recognition Chart...
Page 140: ......
