-24-
Model G0887 (Mfd. Since 01/19)
11. Open coolant valves (see Figure 17).
12. Press coolant pump button (T). Coolant
should flow through blade guides and onto
blade when blade starts in
Step 14.
13. Press raise headstock button (O) and raise
headstock several inches, then press vise
close button (
R).
Note: As a safety precaution, saw motor will
not start unless vise close button is pressed
first.
14. Start blade by pressing blade start button (S)
while keeping your finger near Emergency
Stop button (
A). Verify coolant flows through
blade guides and onto blade and that blade
brush spins. The machine should run smooth-
ly and without unusual problems or noises.
Figure 17. Coolant valve (1 of 3) opened.
Figure 18. G0887 control panel.
A
B
C
D
E
F
G
H
I
J
M
N
O
P
Q
R
S
T
U
V
K
L
— If machine does not run smoothly, dis-
connect machine from power and refer
to
Troubleshooting on Page 60 before
proceeding with
Test Run.
15. Press Emergency Stop button (A) to stop
machine.
Note: Failure indicator Emergency Stop but-
ton light (
K) will illuminate and control panel
will beep to indicate Emergency Stop button
has been pressed and that it must be reset
before operation can resume.
16. WITHOUT resetting Emergency Stop button,
press hydraulic start/stop button (
U), vise
close button (
R), then blade start button (S).
The machine should not start.
— If machine does not start, Emergency Stop
button safety feature is working correctly.
Proceed to
Step 17.
— If machine does start (with Emergency
Stop button pushed in), immediately dis-
connect power. Emergency Stop button
is NOT working properly and must be
replaced before further using machine.
17. Reset Emergency Stop button, press coolant
pump button (
T), press hydraulic start/stop
button (
U), vise close button (R), then blade
start button (
S).
Summary of Contents for G0887
Page 108: ......
