Model G0887 (Mfd. Since 01/19)
-5-
Control Panel
Figure 5. Control panel functions.
K. Emergency Stop Button: Stops all machine
functions. Twist clockwise to reset.
L. Blade Feed Rate Dial: Controls rate at which
blade feeds into workpiece.
M. Auto Cycle Start Button
: Starts automat-
ic cutting cycle. Coolant pump starts, blade
starts, headstock cuts down into workpiece,
saw blade stops, headstock raises, and vise
opens to release workpiece.
N. Cut Counter: The number of completed cuts
is displayed. Push tab to clear.
O. Headstock Angle Joystick: Manually con-
trols angle of headstock after target angle
has been set.
P. Headstock Digital Readout: Displays angle
and height of headstock.
Q. Headstock Increase/Decrease Buttons:
Adjusts headstock height or angle setting
up/down.
R. Height Limit Button
: Enters height limit
entry mode to edit maximum headstock
height.
S. Angle Control Button
: Enters angle
entry mode to edit headstock angle.
T. Coolant Pump Button : Turns coolant
pump
ON and OFF.
U. Motor Stop Button : Turns all motors OFF.
V. Blade Start/Stop Button
: Starts and stops
saw blade and blade brush.
IMPORTANT:
For button to start blade, hydraulic start but-
ton and vise close button must be pressed
first, and headstock raised.
W. Hydraulic Start/Stop Button : Turns
hydraulic motor
ON and OFF.
X. Headstock Height Controls
/
: Adjusts
height of headstock while in manual mode.
Y. Vise Controls
/
: Hydraulically opens
and closes workpiece vise.
Z. Manual Operation Button
: Selects man-
ual operation mode.
AA. Auto Operation Button
: Selects Auto
operation mode.
AB. Failure Indicator: Illuminates to display
where on machine a setting requires operator
intervention.
AC. Power Indicator: Illuminates when machine
is connected to power.
AD. Master Power ON/OFF Key Switch: Turns
incoming power
ON and OFF when key is
inserted.
K
L
M
R
S
T
W
Y
AA
U
V
Q
P
O
Z
AB
N
AC
X
AD
Summary of Contents for G0887
Page 108: ......
