-70-
Model G0887 (Mfd. Since 01/19)
Items Needed
Qty
Hex Wrenches 4, 8mm ................................ 1 ea.
Machinist's Square ............................................ 1
Squaring Blade to
Table
This adjustment has been made at the factory
and should not need to be adjusted under normal
circumstances. However, if you find the saw is not
cutting square, you may need to adjust the blade.
Only make this adjustment after ruling out other
potential factors, such as excessive feed rate or
the blade guide being set too far away from the
workpiece.
To square blade to table:
1. Lower headstock until blade teeth are
approximately even with vise table surface.
2. DISCONNECT MACHINE FROM POWER!
3. Move left blade guide arm all the way left.
4. Open wheel cover by removing (4) button
head cap screws (see
Figure 106). You may
need to move vise support for clearance.
6. Place machinist's square on vise table surface
and against edge of blade (see
Figure 108).
Check for squareness at different points
along length of vise table between blade
guides.
Figure 107. Location of blade guards and blade
guard extension.
Right Blade
Guard
x 2
Left Blade
Guard
Blade Guard
Extension
x 2
Figure 106. Wheel cover secure screws (2 of 4).
5. Remove both blade guards and blade guard
extension by removing (6) button head cap
screws and flat washers (see
Figure 107).
Figure 108. Checking blade-to-table squareness.
Square
Blade
Vise Table
Surface
x 2
Summary of Contents for G0887
Page 108: ......
