Model G0899 (Mfd. Since 10/20)
-17-
Box Contents (Figures 9–11)
Qty
A. Main Table Saw Unit .................................. 1
B. Extension Wings ........................................ 2
C. Saw Blade 10" x 40T .................................. 1
D. Motor Door ................................................. 1
E. Arbor Wrench 13/27mm.............................. 1
F. Dado Table Insert ....................................... 1
G. Blade Guard Dust Port ............................... 1
H. Blade Guard Assembly .............................. 1
I. Hex Wrench 6-Piece Set 2.5-8mm ............ 1
J. Riving Knife ................................................ 1
K. Miter Gauge ................................................ 1
L. Dust Hose Adapters ................................... 2
M. Push Stick .................................................. 1
N. Dado Blade Arbor Flange ........................... 1
O. Dust Port 4" ................................................ 1
P. Handwheels ................................................ 2
Q. Handwheel Lock Knobs ............................. 2
R. Handwheel Handles ................................... 2
S. Dust Hose 94" x 1
1
⁄
2
" .................................. 1
T. Hose Support Arm...................................... 1
U. Dust Hose 3" x 26" ..................................... 1
V. Hose Clamp 3
1
⁄
4
" ........................................ 2
W. Cabinet Access Door ................................. 1
X. Door Latch .................................................. 1
—Phillips Head Screws
8
⁄
32
" x
3
⁄
8
" .............. 2
—Hex Nuts
8
⁄
32
" .......................................... 2
Y. Hinge Pins .................................................. 2
Z. Push Stick Hangar ..................................... 1
—Hex Nuts
1
⁄
4
"-20 ...................................... 2
—Flat Washers 5mm.................................. 2
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Figure 9. Main table saw unit.
A
Figure 10. Extension wings.
B
Figure 11. Component inventory.
C
D
E
F
G
H
I
J
K
L
M
N
P
S
Q
T
U
V
R
O
W
X
Y
Z
Summary of Contents for G0899
Page 92: ......
