Model G0899 (Mfd. Since 10/20)
-27-
Figure 35. Dust hose attached to saw, hose
support, and blade guard dust port.
Hose Support
Blade
Guard
1
1
⁄
2
" Dust Port
4" Dust
Port
1
1
⁄
2
"
Dust Port
Figure 36. Push stick hangar installed.
32. Slide one dust hose adapter onto 1
1
⁄
2
" dust
port (see
Figure 35), until it fits snugly.
33. Attach 1
1
⁄
2
" dust hose to dust hose support
(see
Figure 35), then insert dust hose adapt-
er into 1
1
⁄
2
" dust port at rear of blade guard
assembly.
Dust Collection
Minimum CFM at Dust Port: 500 CFM +
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
This machine creates a lot of wood chips/
dust during operation. Breathing airborne
dust on a regular basis can result in perma-
nent respiratory illness. Reduce your risk
by wearing a respirator and capturing the
dust with a dust-collection system.
Components Needed:
Qty
Dust Hose Adapters 1
1
⁄
2
" ....................................2
Dust Hose 94" x 1
1
⁄
2
" ..........................................1
Dust Hose 4 " (not included) ...............................1
Hose Clamps 4" (not included) ..........................2
Dust Collection System (not included) ...............1
Figure 34. Adapters attached to dust hose.
Dust Hose
Adapters
31. Attach a dust hose adapter to each end of
1
1
⁄
2
" dust hose (see
Figure 34).
Cabinet Access
Door
Push Stick
Hangar
34. Locate hole in cabinet near bottom left corner
of cabinet access door, then open door (see
Figure 36).
35. Remove (1)
1
⁄
4
"-20 hex nut and (1) 5mm flat
washer from push stick hangar (see
Figure
36), then insert hangar into hole.
36. Thread (1)
1
⁄
4
"-20 hex nut with (1) 5mm flat
washer onto end of push stick hangar (see
Figure 36), then close door.
Summary of Contents for G0899
Page 92: ......
