Model G0901 (Mfd. Since 09/19)
-13-
Figure 7. Large parts.
A
B
C
D
E
Figure 8. Small parts.
F
G
H
I
J
K
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Crate Inventory
Qty
A. Lift Bar ........................................................ 1
B. Carriage ...................................................... 1
C. Guide Rails ................................................. 2
D. Track Section, Rear .................................... 1
E. Track Section, Front ................................... 1
F. Caster Bracket w/Brake .............................. 1
G. Caster Brackets .......................................... 3
H. Track Brackets ............................................ 2
I. Lubricant Reservoir w/Hose ....................... 1
J. Adjustable Feet .......................................... 8
K. Log Supports .............................................. 2
L. Blade 144" x 1" x 0.035" (Not Shown) ........ 1
M. Toolbox (Not Shown) .................................. 1
—T-Handle Socket Wrench 17mm ............. 1
—Open-End Wrenches 19/17, 17/14, 13/11,
12/10, 9/8mm .....................................1 Ea
—Flat Screwdriver ...................................... 1
—Phillips Screwdriver ................................ 1
—Hex Wrench Set 2.5-10mm .................... 1
Loose Hardware (Not Shown)
Qty
N. Foot Hardware
— Hex Nuts M16-2 ...................................... 8
O. Track Hardware
—Hex Bolts M10-1.5 x 180 ......................... 2
—Flat Washers 10mm ................................ 8
—Hex Nuts M10-1.5 ................................... 6
—Carriage Bolts M10-1.5 x 25 ................. 16
—Flat Washers 10mm .............................. 16
—Lock Nuts M10-1.5 ................................ 16
P. Guide Rail Hardware
—Carriage Bolts M10-1.5 x 20 ................. 12
—Flat Washers 10mm .............................. 12
—Lock Nuts M10-1.5 ................................ 12
Q. Log Support Hardware
—Hex Bolts M6-1 x 12 ............................... 8
—Flat Washers 6mm ................................. 8
—Lock Washers 6mm ................................ 8
R. Caster Bracket Hardware
—Hex Bolts M8-1.25 x 20 .......................... 8
—Flat Washers 8mm ................................. 8
—Lock Washers 8mm ................................ 8
Summary of Contents for G0901
Page 56: ......
