Model G0920 (Mfd. Since 10/20)
-31-
9. When sandpaper reaches right side of drum,
tuck sandpaper into right slot and clamp with
right clamp. Sandpaper should sit flat against
roller and not overlap at any point.
— If sandpaper does not reach right slot and
clamp you may have inserted sandpaper
too deeply into left slot and clamp. Unwrap
sandpaper and repeat
Steps 7–9.
— If sandpaper does not fit into slot, you may
have placed too little sandpaper into left
slot and clamp. Unwrap sandpaper and
repeat
Steps 7–9.
10. When sandpaper sits flat against roller, does
not overlap at any point, and is secured in
both clamps evenly, close drum door and
secure with lock knob removed in
Step 2.
If sandpaper strip comes loose during oper-
ation, it could cause workpiece to bind and
kickback at operator, which could result in
serious personal injury. Always make sure
sandpaper strip is properly installed and
firmly secured by clamping devices before
connecting sander to power.
Folding
Extension Tables
The extension tables can be folded down and out
of the way when the extra support length is not
needed.
Press the shoulder cap screw shown in
Figure 42
on either side of the extension table you wish to
fold, and table will swing down.
Figure 42. Location of table folding screws.
Note: If the extension tables do not fold when the
above screws are pressed, the shoulder screw in
Figure 43 must be loosened on either side.
Figure 43. Folding bracket shoulder screws.
Shoulder
Screw
Summary of Contents for G0920
Page 60: ......
