Model G0949G (Mfd. Since 01/22)
-61-
4. Remove end gear cover.
5. Remove "L", Z3, and Z4 gears, then place a
two-quart catch pan under drain plug.
6. Remove drain plug (see Figure 90 on Page
60).
7. When reservoir is empty, replace drain plug
and clean up any spilled oil.
8. Fill gearbox reservoir until oil level is approxi-
mately halfway in sight glass (see
Page 61
for gearbox oil capacity).
9. Replace oil gearbox fill plug and gearbox oil
cover.
10. Install "L", Z3, and Z4 gears, then install end
gear cover.
Apron
Oil Type .... Grizzly T23962 or ISO 68 Equivalent
Oil Amount .......................................6.75 Ounces
Check/Add Frequency ................................. Daily
Change .................. Every 1000 Operating Hours
Checking Oil Level
The apron oil sight glass is on the front of the
apron, as shown in
Figure 93. Maintain the oil
volume so that the level is approximately halfway
in the sight glass.
Figure 93. Location of apron oil sight glass.
Changing Oil & Flushing Reservoir
Small metal particles may accumulate at the bot-
tom of the reservoir with normal use. Therefore,
to keep the reservoir clean, drain and flush it after
the first 300 hours, then after every 1000 hours.
Place a catch pan under the apron drain plug
shown in
Figure 94, then remove the fill plug and
drain plug, and empty the reservoir.
Flush the reservoir by pouring a small amount of
clean oil into the fill hole and allowing it to drain
out the bottom. Replace the drain plug, add oil as
previously described, then re-install the fill plug.
Fill Plug
Figure 92. Gearbox fill plug.
Gearbox Oil
Fill Plug
Sight
Glass
Figure 94. Location of apron drain plug.
To change gearbox oil:
1. DISCONNECT MACHINE FROM POWER!
2. Remove gearbox oil cover (see Figure 91 on
Page 60).
3. Remove fill plug from side of gearbox (see
Figure 92).
Drain Plug
Summary of Contents for G0949G
Page 108: ......
