Model G0949G (Mfd. Since 01/22)
-63-
Handling & Care
Make sure to clean and lubricate any gears you
install or change. Be very careful during handling
and storage—the grease coating on the gears will
easily pickup dirt or debris, which can then spread
to the other gears and increase the rate of wear.
Make sure the end-gear cover remains closed
whenever possible to keep the gears free of dust
or debris from the outside environment.
Figure 100. End gears.
E
Figure 99. Tailstock ball oiler.
End Gears
Grease Type ........ T26419 or NLGI#2 Equivalent
Lubrication ................. Every 50 Operating Hours
The end gears, shown in
Figure 100, should
always have a thin coat of heavy grease to
minimize corrosion, noise, and wear. Wipe away
excess grease that could be thrown onto the
V-belt and reduce optimal power transmission
from the motor.
Figure 97. Handwheel ball oilers.
B
Figure 98. Leadscrew/feed rod ball oilers.
C
D
Leadscrew
Feed Rod
C
D
Summary of Contents for G0949G
Page 108: ......
