-26-
Model G1014Z/G1014ZX (Mfd. Since 08/22)
33. Install the 2" dust port onto the back of the
sanding belt frame with the pre-installed
1
⁄
4
"-
20 x
1
⁄
2
" hex bolts and
1
⁄
4
" flat washers, as
shown in
Figure 38.
Figure 40. Belt installed onto idler and drive
rollers.
Drive Roller
Idler
Roller
34. Assemble the quick release lever, as shown
in
Figure 39, using the handle, 6" quick
release lever stud, short lever arm, and (2)
3
⁄
8
"-16 hex nuts.
35. Thread the assembly from Step 34 into the
rocker arm, then tighten the hex nuts (see
Figure 39).
Figure 39. Quick release lever installed.
Handle
Rocker
Arm
Short
Lever
Arm
6" Stud
Hex Nuts
36. Move the quick release lever toward the
motor, slide the sanding belt over the lever
and onto the idler roller and drive rollers, then
center the belt on the rollers (see
Figure 40).
37. Push the lever toward the motor to tension
the sanding belt.
38. Assemble idler roller guard with (2) M5-.8
x 10 thumb knobs, #10 lock washers, and
#10 flat washers, then loosen thumb knobs
behind idler roller, and install idler roller
assembly (see
Figure 41).
Figure 38. 2" dust port installed.
2" Dust
Port
Figure 41. Idler roller guard installed.
Thumb Knob
Idler Roller Guard
