-20-
Model G1015 (Mfg. since 7/99)
SECTION 4: OPERATIONS
Operation Overview
The Model G1015 is a versatile machine that can
perform a number of different tasks. The follow-
ing overview gives you the basic process that
happens during a sanding operation. Familiarize
yourself with this process to better understand the
remaining parts of the
Operation section.
To complete a typical sanding operation, the
operator does the following:
1. Examines the workpiece to make sure it is
suitable for sanding.
2. Installs the correct sanding belt for the opera-
tion (composition and grit).
3. Turns the drive wheel by hand to make sure
the sanding belt is tracking correctly and is
properly tensioned.
4. Verifies that the platen is centered on the
sanding belt.
5. Adjusts the tool rest to the correct position
for the operation and makes sure that it is no
more than
1
⁄
8
" away from the sanding belt.
6. Connects the machine to power and pulls the
ON/OFF button out to turn it
ON.
7. Verifies that the sanding belt is tracking prop-
erly and rotating without interference.
8. Places the workpiece onto the tool rest and
slowly moves it into the sanding belt with the
direction of the belt.
9. Removes the workpiece and pushes the ON/
OFF button in to turn the machine
OFF.
To reduce your risk of
serious injury, read this
entire manual BEFORE
using machine.
Eye injuries, respiratory problems, or hear-
ing loss can occur while operating this
tool. Wear personal protective equipment to
reduce your risk from these hazards.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
Keep hair, clothing, and
jewelry away from mov-
ing parts at all times.
Entanglement can result
in death, amputation, or
severe crushing injuries!
Summary of Contents for G1015
Page 15: ...Model G1015 Mfg since 7 99 13 5mm Hardware Recognition Chart...
Page 40: ......
