-28-
Model G9743 (Mfg. since 12/07)
Blade Change
Blades should be changed when they become
dull, damaged, or when you are using materials
that require a blade of a certain type or tooth
count.
To change the blade on the bandsaw:
1.
UNPLUG THE BANDSAW!
2.
Raise the headstock of the bandsaw to the
highest position, close the Feed ON/OFF
valve, and remove the wheel access cover.
3.
Remove the blade guards.
4.
Loosen the tension handle in Figure 28 and
slip the blade off of the wheels.
5.
Install the new blade through both blade
guide bearings, as shown in Figure 29, and
around the bottom wheel.
Figure 28.
Tension handle and blade.
Figure 29.
Installing blade.
6.
Hold the blade around the bottom wheel with
one hand and slip it around the top wheel with
the other hand, keeping the blade between
the blade guide bearings.
Note:
It is sometimes possible to flip the
blade inside out, in which case the blade will
be installed in the wrong direction. Check to
make sure the blade teeth are facing toward
the workpiece, as shown in
Figure 30
, after
mounting on the bandsaw. Some blades will
have a directional arrow as a guide.
7.
When the blade is around both wheels,
adjust the position so the back of the blade is
against the shoulder of the wheels.
Figure 30.
Blade cutting direction.
Tension Handle
Summary of Contents for G9743
Page 15: ...Model G9743 Mfg since 12 07 13 5mm Hardware Recognition Chart...
Page 47: ...Model G9743 Mfg since 12 07 45 Notes...
Page 51: ......
