H2909 18 Gauge Stapler Kit
-8
-
Cleaning Stapler
Use a good solvent to clean the nose
assembly of the stapler. Always be sure
that the stapler is dry before using it again.
Do not allow dust, chips, sand, etc. into the
air connectors or into the body of the sta-
pler; this may result in leaks and damage
to the stapler and the air couplings.
Never use use gasoline or other flam-
mable liquids to clean this tool.
Vapors in the tool may ignite, causing
the tool to explode. Ignoring this
warning may lead to serious personal
injury or even death!
Always disconnect air from stapler
whenever servicing! During mainte-
nance, a stapler connected to air
may fire accidentally, causing seri-
ous personal injury!
Oiling Stapler
Special oil has been included with your
new Grizzly stapler to help maintain its
useful life. Place one drop of oil in the sta-
pler air inlet (as shown in
Figure 5
) before
every use. Wipe off any excess oil near the
stapler exhaust to avoid dust build-up.
When the oil that was included with the
stapler has been completely used, replace
with Grizzly Model G2820 Pneumatic Tool
Oil.
Another option to manual oiling would be
to install a lubricator in your air compressor
line. If your air compressor line already has
a lubricator, then regular lubrication of your
stapler will not be necessary. Just make
sure there is always oil in the lubricator.
As mentioned before, the best option is to
install a filter/lubricator/regulator unit such
as the Grizzly Model H2333 in your air line.
Figure 5.
Lubricating stapler via air inlet.
